Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programming Ignition Keys To SKIM
2002 Chrysler 300M BaseSECTION Programming Ignition Keys To SKIM
- Connect scan tool to Data Link Connector (DLC), located under left side of instrument panel. See Figure
. Using scan tool, select THEFT ALARM, SKIM then MISC. Select PROGRAM IGNITION KEYS. Obtain 4-digit Personal Identification Number (PIN) from vehicle owner or manufacturer.NOTE: If 3 attempts are made incorrectly to enter PIN, secured access mode will be locked out for one hour. To exit lock out mode, leave ignition switch in ON position for one hour. Ensure battery voltage is maintained with battery charger, if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.