SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2002300M BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS - REMOVAL, OVERHAUL & INSTALLATIONCOMPUTERIZED ENGINE CONTROLSPROGRAMMING SENTRY KEY IMMOBILIZER MODULEPROGRAMMING SKIM
2002 Chrysler 300M Base

Programming SKIM

2002 Chrysler 300M BaseSECTION Programming SKIM
  1. Connect DRBIII® to Data Link Connector (DLC). DLC is located below instrument panel, near steering column. See Figure. Place transmission in Park or Neutral. Turn the ignition on, with the engine off.
  2. With DRBIII®, select THEFT ALARM, SKIM then MISC.
  3. Select SKIM MODULE REPLACEMENT GASOLINE.
  4. Program the 4-digit Personal Identification Number (PIN) into the SKIM.
    5. CAUTION: Enter correct country code in SKIM. If incorrect country code is entered, SKIM must be replaced.
  5. Select COUNTRY CODE and enter the correct country.
  6. Select UPDATE VIN (the SKIM will learn the VIN from the PCM).
  7. Press ENTER to transfer the VIN (the PCM will send the VIN to the SKIM).
  8. The DRBIII® will ask if you want to transfer the secret key from the PCM. This will ensure the current vehicle ignition keys will still operate the Sentry Key Immobilizer System (SKIS).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.