Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Customer Learn Method
Place gear selector in PARK. Turn ignition on. Using a previously programmed transmitter, press UNLOCK button on transmitter for minimum of 4 seconds and while still holding UNLOCK button, press PANIC button. Release both buttons within 10 seconds. BCM will chime. Press any button on each additional transmitter to be programmed. BCM will chime as each button is learned. To exit program mode, turn ignition off, or wait 32 seconds. BCM will chime again.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.