Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Body Verification Test
- Reconnect all previously disconnected components and connectors. Using scan tool, record and erase DTCs from all modules. Cycle ignition on and off.
- If Sentry Key Immobilizer Module (SKIM) or Powertrain Control Module (PCM) was replaced, go to step Β 11 . If SKIM or PCM were not replaced, go to next step.
- If BCM was replaced, turn ignition on for 15 seconds. This allows BCM to learn Vehicle Identification Number (VIN). Engine may not start if equipped with Vehicle Theft Security System (VTSS). If vehicle is equipped with VTSS, use scan tool to enable VTSS.
- Program additional options as necessary.
- If any actuators were replaced on vehicle equipped with manual HVAC system, use scan tool and select HVAC then SYSTEM TESTS, then select HVAC DOOR RECALIBRATION.
- If any actuators were replaced on vehicle equipped with automatic HVAC system, use scan tool and select AUTOMATIC TEMPERATURE CONTROL then MISCELLANEOUS, then select RESET ATC HEAD.
- On vehicles equipped with 3-zone HVAC systems, if HVAC control/rear blower rear control was replaced, DTC REAR BLEND POT CIRCUIT OPEN/SHORT was set or any rear blend pot circuit was repaired, go to next step. If no items were repaired, go to step Β 10 .
- Use scan tool and select HVAC then SYSTEM TESTS, then select HVAC DOOR RECALIBRATION. Door calibration must pass before proceeding to next step.
- Use scan tool and select HVAC then SYSTEM TESTS, then select RESET REAR BLEND SWITCH SPAN. Rotate rear blend/mode control on rear blower rear control to full cold position. Wait 5 minutes and rotate to full hot position.
- If any repairs were made to power sliding door or power liftgate systems, use scan tool and perform open and close system tests. Follow on screen instructions and go to step Β 14 .
- Obtain vehicles unique Personal Identification Number (PIN) assigned to original SKIM from customer or contact manufacturer.NOTE: SKIM will enter secured access mode and will only remain in secured access mode for 60 seconds.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
