Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Dome Switch Input Short
NOTE:
After making any repairs, perform BODY VERIFICATION TESTΒ
under VERIFICATION TESTS.
- Turn ignition off. Disconnect headlight switch. For removal & installation procedures to access connector, see ANALOG INSTRUMENT PANELS - CARAVAN, TOWN & COUNTRY, & VOYAGER article. Locate and disconnect Body Control Module (BCM) connector C5. See COMPONENT LOCATIONSΒ . See Figure . Using DVOM, measure resistance between BCM connector C5 terminals No. 17 (White/Yellow wire) and No. 30 (Orange/Brown wire). If resistance is greater than 1000 ohms, go to next step. If resistance is 1000 ohms or less, repair short between White/Yellow and Orange/Brown wires.
- Using DVOM, measure resistance between ground and BCM connector C5 terminal No. 30 (Orange/Brown wire). If resistance is greater than 1000 ohms, go to next step. If resistance is 1000 ohms or less, repair short to ground in Orange/Brown wire.
- Using DVOM, measure resistance between ground and BCM connector C5 terminal No. 17 (White/Yellow wire). If resistance is greater than 1000 ohms, go to next step. If resistance is 1000 ohms or less, repair short to ground in White/Yellow wire.
- Reconnect headlight switch connector. Using DVOM, measure resistance between ground and BCM connector C5 terminals No. 17 (White/Yellow wire) and No. 30 (Orange/Brown wire). If resistance is greater than 1000 ohms at both terminals, replace BCM. See BODY CONTROL MODULEΒ under REMOVAL & INSTALLATION. If resistance is 1000 ohms or less at either terminal, replace headlight switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
