Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Dome Switch Input Open
NOTE:
After making any repairs, perform BODY VERIFICATION TESTΒ
under VERIFICATION TESTS.
- Turn ignition on. Using scan tool, clear Body Control Module (BCM) DTCs. Turn dome lights on. Recheck for DTCs. If DOME SWITCH INPUT OPEN resets, go to next step. If DOME SWITCH INPUT OPEN does not reset, check for intermittent open, short to voltage or poor connection in White/Yellow wire between headlight switch connector terminal No. 6 and BCM connector C5 terminal No. 30 and repair as necessary. See Figure and Figure .
- Turn ignition off. Locate and disconnect BCM connector C5. See COMPONENT LOCATIONSΒ . See Figure . Disconnect headlight switch connector. For removal and installation procedures to access connector, see ANALOG INSTRUMENT PANELS - CARAVAN, TOWN & COUNTRY, & VOYAGER article. Using DVOM, measure resistance of Orange/Brown wire between headlight switch connector terminal No. 12 and BCM connector C5 terminal No. 30. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Orange/Brown wire.
- Using DVOM, measure resistance of White/Brown wire between headlight switch connector terminal No. 11 and BCM connector C5 terminal No. 18. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in White/Brown wire.
- Reconnect headlight switch connector. Using DVOM, measure voltage between ground and BCM connector C5 terminal No. 18 (White/Brown wire). If voltage is 4.8 volts or less, replace BCM. See BODY CONTROL MODULEΒ under REMOVAL & INSTALLATION. If voltage is greater than 4.8 volts, replace headlight switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
