Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Ignition Run/Start Input Wiring
NOTE:
After making any repairs, perform BODY VERIFICATION TESTΒ
under VERIFICATION TESTS.
- Turn ignition on. Using scan tool, record and erase Front Control Module (FCM) DTCs. Turn ignition off. Start vehicle and monitor scan tool. Recheck for DTCs. If IGNITION RUN/START INPUT WIRING resets, go to next step. If IGNITION RUN/START INPUT WIRING does not reset, conditions necessary to set this DTC are not present at this time. Check for intermittent poor connections or faulty circuits and repair as necessary.
- Turn ignition off. Locate and remove FCM from Intelligent Power Module (IPM). See FRONT CONTROL MODULEΒ under REMOVAL & INSTALLATION. Using DVOM, measure voltage between ground and FCM connector terminal No. 37. See Figure . Turn ignition on. If voltage is 10 volts or less, go to next step. If voltage is greater than 10 volts, replace FCM.
- Turn ignition off. Disconnect IPM connector C9. See Figure . Using DVOM, measure resistance between FCM connector terminal No. 37 and IPM connector C9 terminal No. 2 (IPM side of connector). If resistance is 5 ohms or less, repair open in Pink/White wire between IPM connector C9 terminal No. 2 and ignition switch connector terminal No. 3. If resistance is greater than 5 ohms, replace IPM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
