Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Run/Start Hardwire Input Failure
NOTE:
After making any repairs, perform BODY VERIFICATION TESTΒ
under VERIFICATION TESTS.
- Using scan tool, record and erase DTCs. Turn ignition off and back on. If DTC resets, go to next step. If DTC does not reset, check for intermittent conditions at Body Control Module (BCM) connectors and circuits.
- Turn ignition off. Locate and access ignition switch 5-pin connector. See Figure . Using DVOM connected to ground, backprobe and measure voltage at ignition switch connector terminal No. 3 (Pink/White wire). If voltage is greater than 10 volts, go to next step. If voltage is 10 volts or less, replace ignition switch. See STEERING COLUMN SWITCHES - CARAVAN, TOWN & COUNTRY, & VOYAGER article.
- Locate and access Body Control Module (BCM) connectors. See COMPONENT LOCATIONSΒ . See Figure . Using DVOM connected to ground, backprobe and measure voltage at BCM connector C2 terminal No. 5 (Pink/White wire). If voltage is 10 volts or less, repair open in Pink/White wire. If voltage is greater than 10 volts, replace BCM. See BODY CONTROL MODULEΒ under REMOVAL & INSTALLATION.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
