Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Ignition MUX Switch Input Short
NOTE:
After making any repairs, perform BODY VERIFICATION TESTΒ
under VERIFICATION TESTS.
- Turn ignition off. Disconnect ignition switch 5-pin connector. See Figure . Using scan tool, select SENSORS and monitor IGNITION SW voltage. If scan tool displays 0.0 volts, go to next step. If scan tool does not display 0.0 volts, replace ignition switch. See STEERING COLUMN SWITCHES - CARAVAN, TOWN & COUNTRY, & VOYAGER article.
- Locate Body Control Module (BCM) and disconnect connector C5. See COMPONENT LOCATIONSΒ . See Figure . Using DVOM, measure resistance between ground and BCM connector C5 terminal No. 10 (Violet/Brown wire). If resistance is greater than 5 ohms, go to next step. If resistance is 5 ohms or less, repair short to ground in Violet/Brown wire.
- Disconnect BCM connector C4. See Figure . Using DVOM, measure resistance of Violet/Orange wire between BCM connector C4 terminal No. 14 and ignition switch connector terminal No. 1. If resistance is 5 ohms or less, replace BCM. See BODY CONTROL MODULEΒ under REMOVAL & INSTALLATION. If resistance is greater than 5 ohms, repair open in Violet/Orange wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
