Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Control Module
The Front Control Module (FCM) in part of the Intelligent Power Module (IPM). IPM is located in left front corner of engine compartment, next to battery. See COMPONENT LOCATIONSΒ . The FCM receives hard wire and digital input signals. Based on these inputs, FCM and IPM provide direct power feed and relay control to critical systems. These systems are as follow:
- Front and side air bags.
- Headlight power and exterior light relays.
- Electronic Transaxle Control (EATX) module power (4-speed only).
- Front and rear wiper relays and washer motors.
- Brake/Transmission Shift Interlock (BTSI).
- Horn relay.
- Front and rear blower motor relays.
- Accessory relay.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
