2001 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Body Control Module (1) Attached To Firewall, In Front Of Parking Brake Pedal
Controller Anti-Lock Brake (2) Located In Engine Compartment, Under Master Cylinder
Data Link Connector Left Side Of Steering Column, Attached To Lower Instrument Panel
Diagnostic Junction Port Left Side Of Steering Column, Near Firewall
Front Control Module (3) Attached To Intelligent Power Module
Front Door Cylinder Lock Switch Part Of Door Lock Cylinder
Front Wiper Module (3) Attached To Firewall
Hood Ajar Switch (3) Attached To Left Front Fender
Intelligent Power Module (3) Left Front Corner Of Engine Compartment, Next To Battery
Liftgate Cylinder Lock Switch (4) Part Of Liftgate Lock Cylinder
Memory Seat/Mirror Module (5) Attached To Bottom Of Driver's Seat
Occupant Restraint Controller (6) Behind Center Console Bin In Instrument Panel
Power Liftgate Module (7) Left Rear Corner Of Vehicle, Below Power Liftgate Motor
Power Sliding Door Module (8) Attached To Center Of Power Sliding Door
Powertrain Control Module (3) In Front Of Battery
Remote Keyless Entry Module (9) Left Side Of Instrument Panel Under Upper Trim Pad
Transmission Control Module (10) Left Front Wheelwell, Behind Headlight
(1) See Fig 1 .
(2) See Fig 2 .
(3) See Fig 3 .
(4) See Fig 4 .
(5) See Fig 5 .
(6) See Fig 6 .
(7) See Fig 7 .
(8) See Fig 8 .
(9) See Fig 9 .
(10) See Fig 10 .
Fig 1: Locating Body Control Module
G00030191Courtesy of DAIMLERCHRYSLER CORPORATION
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.