Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programmable Communications Interface Bus System
Programmable Communications Interface (PCI) data bus consist of a pair of twisted wires traveling from module-to-module receiving and delivering coded information. Code identifies message and its importance. When multiple messages attempt to access PCI bus at once, code assigns priority ranking.
Twisted wires used by PCI bus system are called bus "+" (positive) and bus "-" (negative). Both wires carry approximately 2.5 volts. Network consists of some modules with "bias" and some with "termination".
Bias is part of voltage divider network which places both bus "+" and bus "-" at 2.5 volts. Termination is part of circuitry required to complete voltage divider network and also provide some electromagnetic protection for PCI bus. Terminations in all PCI applications have approximately 120 ohms resistance.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
