2001 Chrysler Sebring LimitedFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module

This procedure needs to be completed every time a Powertrain Control Module (PCM) is replaced. Secret key data must be programmed into Sentry Key Immobilizer Module (SKIM) from PCM. See SENTRY KEY IMMOBILIZER MODULEΒ  . Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, select THEFT ALARM, SKIM then MISCELLANEOUS. Then select PCM REPLACED. Enter secured access mode by entering 4-digit pin. Press enter to transfer secret key to new PCM. Now enter Vehicle Identification Number (VIN) and mileage into new PCM. Using scan tool, clear DTCs from ABS and ACM.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.