2001 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

General Information

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2000 Plymouth Voyager, 2000 Plymouth Neon, 2000 Plymouth Grand Voyager, 2000 Plymouth Breeze, and 2000 Dodge Stratus. However, it is still accessible from the selected car via links, so may be relevant.

If Powertrain Control Module (PCM) is replaced, unique secret key data must be transferred from Sentry Key Immobilizer Module (SKIM) to Powertrain Control Module (PCM). This procedure requires SKIM to be placed in SECURED ACCESS mode using 4-digit Personal Identification Number (PIN) code.

If PCM and SKIM are replaced at the same time, program Vehicle Identification Number (VIN) into PCM first. All vehicle keys will need to be replaced and programmed into new SKIM.

SECURED ACCESS mode is not required to check programmed status of key.

If 3 attempts are made to enter secured access mode using an incorrect PIN code, SECURED ACCESS mode will be locked out for one hour. To exit lock out mode, turn ignition switch to on position continuously for one hour then enter the correct PIN code. Ensure all accessories are turned off. Monitor battery state and connect battery charger as necessary.

To program smart keys using "customer programming method" requires 2 valid smart keys. See CUSTOMER LEARN PROGRAMMING METHOD.

CAUTION: If wrong country code is programmed into SKIM when requested, SKIM must be replaced.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.