2001 Chrysler Neon LE, AutomaticFACTORY OEM SERVICE PROCEDURE

VTSS Indicator Fails To Flash

NOTE: After making any repairs, perform BODY VERIFICATION TESTΒ  under VERIFICATION TESTS.
  1. Ensure system is enabled before continuing. Turn ignition off. Disconnect Black 26-pin Remote Keyless Entry (RKE) module connector, located under center of instrument panel top cover. See Figure . Connect a jumper wire between RKE module connector terminal No. 17, Vehicle Theft Security System (VTSS) indicator driver circuit (Black/Orange wire) and ground. See Figure . If VTSS indicator does not illuminate, go to next step. If VTSS indicator illuminates, replace RKE module. See REMOTE KEYLESS ENTRY MODULEΒ  under REMOVAL & INSTALLATION.
  2. Disconnect Black 26-pin instrument cluster connector, located behind left upper instrument panel. Using an ohmmeter, check resistance of VTSS indicator circuit (Black/Orange wire) between RKE module connector terminal No. 17 and instrument cluster connector terminal No. 5. See Figure . If resistance is less than 5 ohms, perform ANY PCI BUS INDICATOR INOPERATIVEΒ  under INSTRUMENT CLUSTER. If resistance is 5 ohms or more, repair open Black/Orange wire.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.