Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Neon (CANADA) L4-2.0LFACTORY OEM SERVICE PROCEDURE
Wiper Control Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove wiper arms.
3. Remove the left side cowl cover. Refer to Body, Exterior, Cowl Cover, Removal.
4. Disconnect the motor posi-lock harness connector.
5. Remove the wiper module mounting screws and remove the module from vehicle.
INSTALLATION
1. Install the windshield wiper module into the vehicle.
2. Install the mounting screws and tighten to 7 to 9 Nm (60 to 80 in. lbs.) torque.
3. Connect the motor posi-lock harness connector.
4. Install the left side cowl cover.
5. Install the wiper arms.
6. Connect the battery negative cable.
Fig.13 Battery Negative Cable Remove/Install:
1. Disconnect and isolate the battery negative cable.
2. Remove wiper arms.
3. Remove the left side cowl cover. Refer to Body, Exterior, Cowl Cover, Removal.
4. Disconnect the motor posi-lock harness connector.
Fig.14 Wiper Module Remove/Install:
5. Remove the wiper module mounting screws and remove the module from vehicle.
INSTALLATION
1. Install the windshield wiper module into the vehicle.
2. Install the mounting screws and tighten to 7 to 9 Nm (60 to 80 in. lbs.) torque.
3. Connect the motor posi-lock harness connector.
4. Install the left side cowl cover.
5. Install the wiper arms.
6. Connect the battery negative cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.