Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Neon (CANADA) L4-2.0LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel top cover.
3. Remove the two screws holding the RKE module to the instrument panel assembly.
4. Slide locking tab of the wiring connector sideways to unlock tab, and remove connector from RKE module.
5. Remove RKE module from vehicle.
NOTE: When replacing a faulty RKE Module, the replacement module must be configured with the DRB III scan tool for proper operation. Refer to Electrical, Vehicle Theft/Security, Standard Procedure - Switching Operating Modes/Configuring a New Module. Additionally, all transmitters must be reprogrammed to the new RKE module.
INSTALLATION
NOTE: When replacing a faulty RKE Module, the replacement module must be configured with the DRB III scan tool for proper operation. Refer to Electrical, Vehicle Theft/Security, Standard Procedure - Switching Operating Modes/Configuring a New Module. Additionally, all transmitters must be reprogrammed to the new RKE module.
1. Install the RKE module into the vehicle.
2. Connect the RKE wiring connector.
3. Install the two screws holding the RKE module to the instrument panel assembly.
4 Install the instrument panel top cover.
5. Connect the battery negative cable.
Fig.1 Battery Negative Cable Remove/Install:
1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel top cover.
RKE Module Location:
3. Remove the two screws holding the RKE module to the instrument panel assembly.
4. Slide locking tab of the wiring connector sideways to unlock tab, and remove connector from RKE module.
5. Remove RKE module from vehicle.
NOTE: When replacing a faulty RKE Module, the replacement module must be configured with the DRB III scan tool for proper operation. Refer to Electrical, Vehicle Theft/Security, Standard Procedure - Switching Operating Modes/Configuring a New Module. Additionally, all transmitters must be reprogrammed to the new RKE module.
INSTALLATION
NOTE: When replacing a faulty RKE Module, the replacement module must be configured with the DRB III scan tool for proper operation. Refer to Electrical, Vehicle Theft/Security, Standard Procedure - Switching Operating Modes/Configuring a New Module. Additionally, all transmitters must be reprogrammed to the new RKE module.
1. Install the RKE module into the vehicle.
2. Connect the RKE wiring connector.
3. Install the two screws holding the RKE module to the instrument panel assembly.
4 Install the instrument panel top cover.
5. Connect the battery negative cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.