Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Memory System
The memory switch is located on front outboard side of driver's seat. To program memory system for first driver, adjust driver's seat, outside mirrors and radio station to desired settings. Press and release memory switch "S" button. Within 5 seconds, press and release memory switch No. 1 button. To program memory system for second driver, repeat procedure and select memory switch No. 2 button. To recall desired memory settings, press and release appropriate memory switch button.
To recall memory positions using a programmed Remote Keyless Entry (RKE) transmitter, press UNLOCK button on transmitter. All memory settings will return to recalled position. To set stored positions in RKE, see SETTING MEMORY POSITIONS IN REMOTE KEYLESS ENTRY SYSTEMΒ under PROGRAMMING. Memory recall using RKE can only be performed when vehicle transmission is in Park position. Module will abort RKE memory recall if seat is manually moved or vehicle is shifted from Park position while memory recall is in operation. RKE memory function can be disabled. See PROGRAMMINGΒ .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
