2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Connectors

CONNECTORS LOCATION

Component Location
C101 (Black, 14 Pin) At left front of engine. See Figure.
C102 (Black, 10 Pin) At left front of engine. See Figure.
C103 (Green, 22 Pin) At left side of dash.
C104 (Orange, 4 Pin) At left side of dash.
C105 (Yellow, 3 Pin) At left side of dash.
C106 (White, 10 Pin) At left side of dash.
C107 (Light Gray, 14 Pin) At rear of engine. See Figure.
C108 (Light Gray, 10 Pin) At rear of engine. See Figure.
C109 (Black, 6 Pin) Under left front headlight.
C110 (Black, 2 Pin) At rear of engine.
C113 (Light Gray, 10 Pin) Under left headlight.
C114 (Black, 13 Pin) Under left headlight.
C200 (Blue, 22 Pin) At left side of dash.
C201 (White, 13 Pin) At right side of dash.
C202 (White, 16 Pin) At lower center of dash.
C203 (White, 16 Pin) At lower center of dash.
C204 (Natural, 8 Pin) At headliner.
C205 (Natural, 4 Pin) At lower center of dash.
C206 (Natural, 2 Pin) At left side of dash.
C300 (24 Pin) Left kick panel.
C301 (16 Pin) Left kick panel.
C302 (16 Pin) Right kick panel.
C303 (16 Pin) Right kick panel.
C304 (White, 10 Pin) Left "B" pillar.
C305 (White, 10 Pin) Right "B" pillar.
C306 (Black, 2 Pin) Under passenger seat.
C307 (Black, 2 Pin) Under driver seat.
C308 (Black, 6 Pin) Under rear seat.
C309 (Yellow, 2 Pin) Under driver seat.
C310 (Yellow, 2 Pin) Under passenger seat.
C311 (Red, 6 Pin) Left trunk area.
C312 (Black, 2 Pin) Left trunk area.
C313 (Gray, 6 Pin) Right trunk area.
C314 (Gray, 6 Pin) Left trunk area.
C315 (Black, 3 Pin) Left trunk area.
C316 (Natural, 2 Pin) Left "B" pillar.
C317 (Natural, 2 Pin) Right "B" pillar.
C318 (Natural, 8 Pin) Under passenger seat.
C319 (Natural, 22 Pin) Under driver seat.
C320 (Natural, 2 Pin) Bottom of rear shelf.
C321 (Natural, 2 Pin) On deck lid.
C322 (Black, 3 Pin) Under driver seat.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.