Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
- If VCM was replaced, the EEPROM in the VCM must be programmed. If EEPROM is not programmed, a DTC will be set.
- Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Turn ignition switch to ON position. Perform EEPROM programming using Techline® equipment. Follow manufacturer's instructions and latest software applicable for vehicle model.
- Once EEPROM is reprogrammed, CKP sensor variation learn procedure and password learn procedure for anti-theft system must be performed. See CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE . See PASSWORD LEARN PROCEDURE FOR ANTI-THEFT SYSTEM .NOTE: If EEPROM programming fails, ensure all harness connections on VCM are okay. Check Techline® for latest software. If EEPROM programming still fails, replace VCM.
- Once CKP sensor variation learn procedure and password learn procedure for anti-theft system are performed, perform Powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.