Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Retrieving DTCS: Notes
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2000 Plymouth Neon, 2000 Plymouth Breeze, 2000 Dodge Stratus, 2000 Dodge Neon, and 2000 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Self-diagnostic tests are written specifically for Chrysler's Diagnostic Readout Box (DRB-III) scan tool, which will be referred to as scan tool during test procedures. A generic scan tool may also be used for system diagnostics, but may have limited diagnostic capability.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.