Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0125: Closed Loop Temp Not Reached: Description
Closed loop operation is monitored for 10 minutes after engine is started when battery voltage is more than 10.4 volts. DTC will set in Powertrain Control Module (PCM) memory when PCM senses that engine coolant temperature does not go to more than 60Β°F (15Β°C) within 10 minutes after engine is started. Two trips are required to set this DTC. Possible causes are: defective thermostat or low coolant level.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
