2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Remote Keyless Entry Horn Chirp Inoperative

  1. Turn ignition on. Press horn pad on steering wheel. If horn is operating properly, go to next step. If horn does not operate properly, repair horn as necessary. See HORN SYSTEM under TROUBLESHOOTING in STEERING COLUMN SWITCHES - CONCORDE, INTREPID, LHS & 300M article.
  2. Verify that horn chirp is enabled. See PROGRAMMING HORN ENABLE/DISABLEΒ  under programming. If horn is enabled and horn chirp is inoperative, repair horn as necessary. See HORN SYSTEM under TROUBLESHOOTING in STEERING COLUMN SWITCHES - CONCORDE, INTREPID, LHS & 300M article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.