Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Body Control Module | On Back Of Junction Block |
| Data Link Connector | Under Left Side Of Instrument Panel, Above Brake Pedal |
| Deck Lid Release Switch | Left Side Of Instrument Panel, Above Parking Brake Release |
| Door Lock Switch | On Appropriate Door Panel |
| Ignition Switch | In Right Side Of Steering Column |
| Junction Block | Behind Left End Of Instrument Panel |
| Power Distribution Center | Left Side Of Engine Compartment |
| Powertrain Control Module | Left Side Of Engine Compartment |
| Remote Keyless Entry Module | Between BCM & Junction Block, On Back Of Junction Block |
| Sentry Key Immobilizer Module | In Steering Column, By Ignition Switch |
| Sun Sensor/Vehicle Theft Security System LED | Top Center Of Instrument Panel |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
