Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Anti-Theft System: Description
Optional Vehicle Theft Security System (VTSS) is designed for entire vehicle theft protection. System monitors doors, hood, trunk key cylinder and ignition switch for unauthorized operation. If vehicle is locked by manually pushing down the door lock mechanism, alarm will not arm. When system is triggered, horn will sound, and headlights, parking lights, taillights and VTSS indicator light will flash. After 3 minutes, horn will stop sounding, but lights will continue to flash for another 15 minutes. VTSS will reset after it has been triggered and system has timed out for 18 minutes. When unauthorized entry has occurred, VTSS activates an engine kill feature. Vehicle will not start until VTSS is disarmed using key or Remote Keyless Entry (RKE) system transmitter. For additional information on RKE system, see REMOTE KEYLESS ENTRY SYSTEMS - NEON article.
Vehicles with VTSS are also equipped with a Sentry Key Immobilizer System (SKIS). SKIS is designed to prevent vehicle engine operation. SKIS consists of the Sentry Key Immobilizer Module (SKIM), sentry transponder keys, VTSS indicator LED and Powertrain Control Module (PCM). SKIM is located on steering column, next to ignition switch. Transponder is located in ignition key. See Fig 1 . If an invalid ignition key is used, SKIM will send invalid signal to PCM, causing engine to start and run for 2 seconds, then stop. If vehicle is started with invalid keys 6 times in a row, vehicle will shutdown until correct key is used.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
