Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Data Link Connector (DLC) | Under Left Side Of Instrument Panel |
| Fuse Block | Left Side Of Instrument Panel |
| Mechanical Instrument Cluster (MIC) Module | Integral Part Of Instrument Cluster |
| Powertrain Control Module (PCM) | Engine Compartment, Between Air Cleaner & Radiator |
| Power Distribution Center (PDC) | Left Rear Of Engine Compartment, Next To Battery |
| Remote Keyless Entry (RKE) Module | Center Of Instrument Panel, Under Top Cover |
| Sentry Key Immobilizer Module (SKIM) | On Steering Column, Next To Ignition Switch |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
