2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Wiper Not Wiping After Wash

NOTE: After making any repairs, perform BODY CONTROL MODULES SYSTEM VERIFICATION TESTΒ  under VERIFICATION TESTS.
  1. Turn ignition on. Operate wipers in all speeds. If wipers operate properly, go to next step. If wipers do not operate properly, repair by symptom. Perform appropriate test under WINDSHIELD WIPER SYSTEM. See SYMPTOM IDENTIFICATIONΒ  table under SELF-DIAGNOSTIC SYSTEM.
  2. Turn wipers off. Turn ignition off. Disconnect Body Control Module (BCM) connector C2. Turn ignition on. Connect a 12-volt test light between ground and BCM connector C2 terminal No. 7, washer pump control switch output circuit (Brown wire). See Figure . Monitor test light while pressing and releasing washer switch. If test light flashes, replace BCM. If test light does not flash, repair open in Brown wire.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.