Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Remote Keyless Entry Horn Chirp Inoperative
NOTE:
After making any repairs, perform BODY CONTROL MODULES SYSTEM VERIFICATION TEST
under VERIFICATION TESTS.
- Press horn pad on steering wheel. If horn is operating properly, go to next step. If horn does not operate properly, repair horn as necessary. See HORN SYSTEM under TROUBLE SHOOTING in appropriate STEERING COLUMN SWITCHES article.
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Using scan tool, read HORN CHIRP status. If scan tool displays ENABLED, go to next step. If scan tool does not display ENABLED, enable horn chirp using scan tool.
- Turn ignition off. Remove Body Control Module (BCM) from back of junction block. Momentarily connect a fused jumper wire between ground and terminal No. 18 at BCM connector on back of junction block. See Figure . If horn sounds, replace BCM. If horn does not sound, replace junction block.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.