Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Passenger Mirror Vertical Sensor Out Of Range High
NOTE:
After making any repairs, perform MEMORY SYSTEMS VERIFICATION TEST
under VERIFICATION TESTS.
- Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM) connector C1. Turn ignition on. Measure voltage on MHSMM connector C1 terminal No. 6, passenger mirror vertical position signal circuit (Yellow/Red wire). See Figure . If voltage is more than 4.5 volts, leave MHSMM connector C1 disconnected, and go to next step. If voltage is 4.5 volts or less, replace MHSMM.
- Turn ignition off. Disconnect passenger mirror connector. Turn ignition on. Measure voltage on passenger mirror connector terminal No. 7, passenger mirror vertical position signal circuit (Yellow/Red wire). See Figure and Figure . If any voltage exists, repair short to voltage in Yellow/Red wire. If no voltage exists, replace passenger mirror.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.