Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
Driver Mirror Vertical Sensor Out Of Range Low
NOTE:
After making any repairs, perform MEMORY SYSTEMS VERIFICATION TEST
under VERIFICATION TESTS.
- Turn ignition off. Disconnect Memory Heated Seat/Mirror Module (MHSMM) connector C1. Turn ignition on. Measure voltage on MHSMM connector C1 terminal No. 7, driver mirror vertical position signal circuit (Yellow/Orange wire). See Figure . If voltage is 4.5-5.0 volts, replace MHSMM. If voltage is not 4.5-5.0 volts, leave MHSMM connector C1 disconnected, and go to next step.
- Turn ignition off. Disconnect driver mirror connector. Measure resistance of driver mirror vertical position signal circuit (Yellow/Orange wire) between driver mirror connector terminal No. 7 and MHSMM connector C1 terminal No. 7. See Figure . If resistance is less than 5 ohms, leave connectors disconnected, and go to next step. If resistance is 5 ohms or more, repair open in Yellow/Orange wire.
- Measure resistance between ground and driver mirror connector terminal No. 7, driver mirror horizontal position signal circuit (Yellow/Orange wire). If resistance is less than 100 ohms, repair short to ground in Yellow/Orange wire. If resistance is 100 ohms or more, leave driver mirror connector disconnected, and go to next step.
- Ensure MHSMM connector is properly connected. Turn ignition on. Measure voltage on driver mirror connector terminal No. 6, driver mirror 5-volt supply circuit (Gray/Light Blue). If voltage is 4.5-5.0 volts, replace driver mirror. If voltage is not 5.5-5.0 volts, leave driver mirror connector disconnected, and go to next step.
- Turn ignition off. Disconnect MHSMM connector C2. Measure resistance of driver mirror 5-volt supply circuit (Gray/Light Blue wire) between driver mirror connector terminal 6 and MHSMM connector C2 terminal No. 7. If resistance is less than 5 ohms, replace MHSMM. If resistance is 5 ohms or more, repair open in Gray/Light Blue wire.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.