Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE
No PCI Messages From CD Changer
NOTE:
After making any repairs, perform BODY CONTROL MODULES SYSTEM VERIFICATION TEST
under VERIFICATION TESTS.
- Turn ignition off. Connect scan tool to Data Link Connector (DLC). Turn ignition on. Turn radio on. Using scan tool, select BODY, then RADIO. If scan tool communicates with radio, go to next step. If scan tool does not communicate with radio, perform NO RESPONSE FROM RADIO OR BUS +/- SIGNALS OPEN test.
- Turn radio off. Turn ignition off. Disconnect CD changer DIN cable connector. Disconnect radio DIN cable Black connector C4. Visually inspect DIN cable connectors and connecting DIN cable for damage. Repair or replace as necessary. If connectors and cable appear okay, go to next step.
NOTE:
CD changer DIN cable connector view is not available from manufacturer. For Radio DIN cable Black connector C4 view, see illustration. See Fig 1
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.