Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid (CANADA) V6-3.5LFACTORY OEM SERVICE PROCEDURE
Quick Learn Function
QUICK LEARN
The Quick Learn function customizes adaptive parameters of the TCM to the transmission characteristics of a vehicle. This gives the customer improved "as received" shift quality compared to the initial parameters stored in the TCM.
Notes about Quick Learn Features
- The shift lever position must stay in neutral until prompted to shift into OD.
- The shift lever must stay in OD after the "Shift to Overdrive" prompt until the DRBIII(R) indicates the procedure is complete.
- The oil temperature must be between 60 and 200°F.
NOTE: THE ABOVE CONDITIONS MUST BE MAINTAINED DURING THE PROCEDURE TO KEEP THE PROCEDURE FROM BEING ABORTED.
The Quick Learn procedure is performed with the "Transmission" system then "Miscellaneous" functions, then "Quick Learn". Follow the procedure instructions displayed on the radio.
The Quick Learn function customizes adaptive parameters of the TCM to the transmission characteristics of a vehicle. This gives the customer improved "as received" shift quality compared to the initial parameters stored in the TCM.
Notes about Quick Learn Features
- The shift lever position must stay in neutral until prompted to shift into OD.
- The shift lever must stay in OD after the "Shift to Overdrive" prompt until the DRBIII(R) indicates the procedure is complete.
- The oil temperature must be between 60 and 200°F.
NOTE: THE ABOVE CONDITIONS MUST BE MAINTAINED DURING THE PROCEDURE TO KEEP THE PROCEDURE FROM BEING ABORTED.
The Quick Learn procedure is performed with the "Transmission" system then "Miscellaneous" functions, then "Quick Learn". Follow the procedure instructions displayed on the radio.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.