Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid (CANADA) V6-3.5LFACTORY OEM SERVICE PROCEDURE
Memory Positioning Switch: Testing and Inspection
1. Disconnect and isolate the battery negative cable.
2. Remove the driver side front seat side shield. Refer to Body for the procedure.
3. Disconnect the memory switch wire harness connector from the memory switch.
4. Use an ohmmeter to test for continuity between the memory switch terminals.
5. Connect one end of the ohmmeter to pin #3. While holding the memory 1 button check for continuity with pin #6. If not OK, replace the faulty memory switch.
6. Connect one end of the ohmmeter to pin #3. While holding the memory 2 button check for continuity with pin #4. If not OK, replace the faulty memory switch.
7. Connect one end of the ohmmeter to pin #3. While holding the memory S button check for continuity with pin #5. If not OK, replace the faulty memory switch.
8. If OK, refer to Memory System in the Diagnosis and Testing. If not OK, replace the faulty memory switch.
2. Remove the driver side front seat side shield. Refer to Body for the procedure.
3. Disconnect the memory switch wire harness connector from the memory switch.
4. Use an ohmmeter to test for continuity between the memory switch terminals.
5. Connect one end of the ohmmeter to pin #3. While holding the memory 1 button check for continuity with pin #6. If not OK, replace the faulty memory switch.
6. Connect one end of the ohmmeter to pin #3. While holding the memory 2 button check for continuity with pin #4. If not OK, replace the faulty memory switch.
7. Connect one end of the ohmmeter to pin #3. While holding the memory S button check for continuity with pin #5. If not OK, replace the faulty memory switch.
8. If OK, refer to Memory System in the Diagnosis and Testing. If not OK, replace the faulty memory switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.