Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid (CANADA) V6-3.2LFACTORY OEM SERVICE PROCEDURE
Pinion Factor Setting
STANDARD PROCEDURES
The vehicle speed readings for the speedometer are taken from the output speed sensor. The TCM must be calibrated to the different combinations of equipment available. Pinion Factor allows the technician to set the Transmission Control Module initial setting so that the speedometer readings will be correct.
This procedure must be performed if the Transmission Control Module has been replaced. Failure to perform this procedure will result in an inoperative speedometer.
To properly read or reset the Pinion Factor, it is necessary to use a DRB III scan tool. Perform the following steps with the DRB III scan tool to read or reset the Pinion Factor:
1. Plug the DRB III scan tool into the data link connector located under the instrument panel.
2. Select the Transmission menu.
3. Select the Miscellaneous menu.
4. Select Pinion Factor. Then follow the instructions on the DRB III scan tool screen.
The vehicle speed readings for the speedometer are taken from the output speed sensor. The TCM must be calibrated to the different combinations of equipment available. Pinion Factor allows the technician to set the Transmission Control Module initial setting so that the speedometer readings will be correct.
This procedure must be performed if the Transmission Control Module has been replaced. Failure to perform this procedure will result in an inoperative speedometer.
To properly read or reset the Pinion Factor, it is necessary to use a DRB III scan tool. Perform the following steps with the DRB III scan tool to read or reset the Pinion Factor:
1. Plug the DRB III scan tool into the data link connector located under the instrument panel.
2. Select the Transmission menu.
3. Select the Miscellaneous menu.
4. Select Pinion Factor. Then follow the instructions on the DRB III scan tool screen.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.