Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chrysler Intrepid (CANADA) V6-3.2LFACTORY OEM SERVICE PROCEDURE
Electronic Pinion Factor
ELECTRONIC PINION FACTOR
The transmission output speed signal supplies distance pulses to the powertrain control module (PCM), which are used to calculate speed and mileage. A pinion factor is stored in the transmission control module (TCM) in order to provide the appropriate distance pulses for the vehicle. The pinion factor is programmed into the TCM at the assembly plant.
Using the following steps, the pinion factor can be checked and/or reset using the DRBIII(R):
1 Select "Transmission" system, then "Miscellaneous" functions, then "Pinion factor". The DRBIII(R) will display the current tire size.
2 If the tire size is incorrect, depress the Enter key and then select the correct size.
3 Depress the Page Back key to exit the reset procedure.
Notes About Electronic Pinion Factor Features
The nature of the electronic pinion factor requires that certain features must be taken into consideration.
- If no pinion factor is stored in an installed TCM, the vehicle speedometer will not operate, engine speed will be limited to 2300 RPM, and catalyst damage may occur.
- Selecting a wrong FOR or tire size will cause the speedometer to be inaccurate and will also cause any speed related features to operate improperly.
NOTE: AFTER REPLACING THE TCM, YOU MUST REPROGRAM PINION FACTOR
The transmission output speed signal supplies distance pulses to the powertrain control module (PCM), which are used to calculate speed and mileage. A pinion factor is stored in the transmission control module (TCM) in order to provide the appropriate distance pulses for the vehicle. The pinion factor is programmed into the TCM at the assembly plant.
Using the following steps, the pinion factor can be checked and/or reset using the DRBIII(R):
1 Select "Transmission" system, then "Miscellaneous" functions, then "Pinion factor". The DRBIII(R) will display the current tire size.
2 If the tire size is incorrect, depress the Enter key and then select the correct size.
3 Depress the Page Back key to exit the reset procedure.
Notes About Electronic Pinion Factor Features
The nature of the electronic pinion factor requires that certain features must be taken into consideration.
- If no pinion factor is stored in an installed TCM, the vehicle speedometer will not operate, engine speed will be limited to 2300 RPM, and catalyst damage may occur.
- Selecting a wrong FOR or tire size will cause the speedometer to be inaccurate and will also cause any speed related features to operate improperly.
NOTE: AFTER REPLACING THE TCM, YOU MUST REPROGRAM PINION FACTOR
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
