2000 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE

Body Verification Test

  1. Reconnect all previously disconnected components and connectors. If Body Control Module (BCM) was replaced, you must enable the Vehicle Theft Security System (VTSS) or anti-theft system (if equipped) by using the key to unlock the liftgate while hood is open. VTSS will function fully after 4 engine cranking cycles have been performed. If BCM was replaced you must program other options as necessary.
    NOTE: To enable automatic headlight operation, vehicle must be driven more than 3 miles and BCM must see one key transmission from the remote keyless entry transmitter.
  2. Ensure ignition is on. Using scan tool, clears all DTCs. Turn ignition off and wait 5 seconds. Turn ignition on and fully operate system that was malfunctioning.
  3. If system is operating properly, continue to the next step. If system is not operating properly, check possible causes for the malfunction.
  4. Using scan tool, read DTCs stored in the BCM. If no DTCs exist and customer's complaint cannot be duplicated, test is complete. If any DTCs exist, perform appropriate test for the DTC. See DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table under SELF-DIAGNOSTIC SYSTEM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.