Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Without Scan Tool
- To use this method of programming, a previously programmed transmitter must be used. Ensure transmitter batteries have about 3.2 volts each. Turn ignition on. Place transmission in Park. If vehicle is equipped with anti-theft system, ensure system is in disarm mode.
- Using a previously programmed transmitter, press and hold unlock button 5-10 seconds. While still holding unlock button down, press panic button, then release both buttons. Chime should sound once to indicate Body Control Module (BCM) has grounded the RKE module program enable wire. Press any button on transmitter. Chime should sound once to indicate RKE module has accepted the signal.
- Repeat step 2) for all transmitters that will be used by vehicle. Up to a total of 4 transmitters can be programmed. Programming mode will last for 30 seconds. To exit programming mode sooner, turn ignition off.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.