Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Compass Calibration
When CAL indicator is illuminated on compass/mini-trip computer, calibration is necessary before compass will display a direction. To calibrate compass, find a level surface free of buildings, trees, underground cables, train tracks and other vehicles. Drive vehicle in circles, keeping steering wheel in one steady position, at a speed of 7-10 MPH until the CAL indicator turns off. This could take between 2 and 6 complete circles to perform. The CAL indicator will come on again briefly, indicating calibration is complete. Check operation of compass. If compass does not operate properly, perform recalibration procedure in another location.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.