2000 Chrysler Sebring LXiFACTORY OEM SERVICE PROCEDURE

Updating Secret Key Data

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 1999 Plymouth Voyager, 1999 Plymouth Neon, 1999 Plymouth Grand Voyager, 1999 Plymouth Breeze, and 1999 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Connect scan tool to Data Link Connector (DLC) below driver's side of instrument panel. Go to ENGINE, then MISC menu on scan tool. Place the SKIM in SECURED ACCESS MODE by using the appropriate Personal Identification Number (PIN) for this vehicle. PIN may be obtained from the owner, vehicle's invoice, or from the manufacturer. Select UPDATE THE SECRET KEY DATA. The data will be transferred from Smart Key Immobilizer Module (SKIM) to the PCM.

NOTE: If 3 attempts are made to enter the SECURED ACCESS MODE using the incorrect Personal Identification Number (PIN), the SECURED ACCESS MODE will be locked out for one hour. To exit this locked-out mode, leave ignition switch in the ON position for one hour with all accessories turned off. It may be necessary to monitor battery state and connect a battery charger.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.