Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Sebring LXFACTORY OEM SERVICE PROCEDURE
Programming RKE Transmitter With Scan Tool
- Ensure ignition is off. Connect scan tool to 16-pin Data Link Connector (DLC). DLC is located under instrument panel, to right of steering column. See Fig 1 . Close both doors. Turn ignition switch to ACC position, then turn back to LOCK position.
- Press any transmitter button 3 times within 10 seconds. Door will lock and unlock once. If programming a second transmitter, press any button 3 times on second transmitter within one minute of programming first transmitter. Door will again lock and unlock once.
- Programming mode will be cancelled under one of the following conditions:
- Programming of 2 transmitters is completed.
- One minute has passed since programming was completed.
- Scan tool is disconnected.
- Ignition is turned off.
- Any door is opened.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.