2000 Chrysler Neon LE, AutomaticFACTORY OEM SERVICE PROCEDURE

Final Procedure

  1. Connect scan tool to Data Link Connector (DLC). Using scan tool, monitor conditions to attempt to duplicate the conditions that vehicle was operating at when DTC was set. If conditions can be duplicated, good trip counter will change to one or more.
  2. If conditions cannot be duplicated, clear DTCs from PCM. Disconnect scan tool from DLC. If the repaired OBD-II DTC was reset, or OBD-II monitor failed after running, the repair is not complete. Check for related Technical Service Bulletins (TSBs) or flash updates. If repaired DTC or another DTC exists, perform appropriate DTC or symptom test.
  3. If the monitor ran and good trip counter changed to one or more, the repair was successful. Clear DTCs from PCM. Repair is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.