Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Neon LE, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| A/C Cycling Switch | Center of HVAC housing. |
| A/C High Pressure Switch | On rear of A/C compressor. See Figure . |
| A/C Low Pressure Switch | On expansion valve. See Figure . |
| Back-Up Lamp Switch (A/T) | Integral with park/neutral position switch. |
| Back-Up Lamp Switch (M/T) | On top of transmission. See Figure . |
| Brake Warning Indicator Switch | On master cylinder. See Figure . |
| Clutch Interlock Switch | On clutch pedal bracket. |
| Engine Oil Pressure Switch | On right side of engine block. |
| Park/Neutral Position Switch | On left side of transmission. See Figure . |
| Power Steering Pressure Switch | On power steering gear. See Figure . |
| Seat Belt Switch | Under driver's seat. |
| Stoplight Switch | Top of brake pedal support. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
