2000 Chrysler Neon (CANADA) L4-2.0LFACTORY OEM SERVICE PROCEDURE

Ignition Coil: Service and Repair

Electronic Ignition Coil Pack:

Factory service manual diagram



The electronic ignition coil pack attaches directly to the valve cover.

REMOVAL

Electronic Ignition Coil Connector:

Factory service manual diagram



1. Disconnect electrical connector from coil pack.
2. Remove coil pack mounting bolts.
3. Remove coil pack.

INSTALLATION
1. Install coil pack on valve cover.
2. Transfer spark plug cables to new coil pack. The coil pack towers are numbered with the cylinder identification. Be sure the ignition cables snap onto the towers.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.