Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler LHSFACTORY OEM SERVICE PROCEDURE
VTSS Will Not Arm
- Check power door locks and remote keyless entry system operation. If power door locks and remote keyless entry system operates properly, go to next step. If power door locks and remote keyless entry system do not operate properly, perform appropriate test under POWER DOOR LOCKS/RKE SYSTEM .
- Connect scan tool to Data Link Connector (DLC). Close all doors and trunk. Turn ignition on. Using scan tool, check all door ajar switches status. If OPEN is displayed for all switches, replace BCM. If OPEN is not displayed for all switches, repair door ajar circuits as necessary. Perform appropriate test under INTERIOR LIGHTING SYSTEMS .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.