2000 Chrysler Intrepid ESFACTORY OEM SERVICE PROCEDURE

Removal & Installation

WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: SKIM is located in steering column, by ignition switch. See Figure .

Disconnect negative battery cable. Remove knee bolster. Remove upper and lower steering column covers. Disengage steering column wire retainer from SKIM. Remove SKIM retaining screw. Disconnect SKIM connector. Slide SKIM from around ignition switch and remove SKIM. To install, reverse removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.