2000 Chrysler Intrepid ESFACTORY OEM SERVICE PROCEDURE

Window Motor

  1. Remove appropriate door trim panel. See DOOR TRIM PANEL  under REMOVAL & INSTALLATION. Disconnect window motor connector. Using jumper wires, apply battery voltage and ground across window motor terminals. Motor should operate, unless it is already at maximum travel. Reverse jumper wires. Motor should operate in opposite direction.
  2. If window does not move in either direction, remove screws holding glass lift plate to regulator. Slide window up and down by hand to ensure it moves freely in glass channels. Check regulator assembly. Repair window and/or regulator as necessary. If window and regulator are okay, replace window motor. If motor operates in one direction only, replace motor. See WINDOW MOTOR  under REMOVAL & INSTALLATION.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.