Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Chrysler Intrepid ESFACTORY OEM SERVICE PROCEDURE
Low Washer Fluid Indicator Not Operating Properly
- Turn ignition off. Check washer fluid level. If fluid level is okay, go to next step. If fluid level is not okay, fill as necessary.
- If low washer fluid indicator does not illuminate, go to next step. If low washer fluid indicator is illuminated at all times, go to step 7 .
- Turn ignition on and observe door ajar indicator. If low washer fluid indicator illuminates for 3-10 seconds, go to next step. If low washer fluid indicator does not illuminate for 3-10 seconds, replace instrument cluster.
- Turn ignition off. Disconnect washer fluid level switch harness connector. Measure resistance between ground and terminal No. 1 (Black wire) at washer fluid level switch harness connector. If resistance is 10 ohms or less, go to next step. If resistance is greater than 10 ohms, repair open in Black wire between washer fluid level switch and ground.
- Disconnect instrument cluster harness connector C2. Measure resistance in Black/Tan wire between terminal No. 1 at washer fluid level switch harness connector and terminal No. 4 at instrument cluster harness connector C2. See Figure . If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in Black/Tan wire between washer fluid level switch and instrument cluster.
- Connect instrument cluster harness connector C2. Using a fused jumper wire, connect terminals No. 1 (Black wire) and No. 2 (Black/Tan wire) at washer fluid level switch harness connector. Turn ignition on. If low washer fluid indicator illuminates, replace washer fluid level switch. If low washer fluid indicator does not illuminate, replace instrument cluster.
- Turn ignition off. Disconnect washer fluid level switch harness connector. Turn ignition on and wait for one minute. If low washer fluid indicator is still illuminated, go to next step. If low washer fluid indicator turns off, replace washer fluid level switch.
- Turn ignition off. Disconnect instrument cluster harness connector C2. Measure resistance between ground and terminal No. 4 (Black/Tan wire) at instrument cluster harness connector C2. See Figure . If resistance is greater than 5 ohms, replace instrument cluster. If resistance is 5 ohms or less, repair short to ground in Black/Tan wire between washer fluid level switch and instrument cluster.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.