2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Midline/Infinity I System

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove right under panel silencer/duct.
  3. Remove mounting fastener to remote amplifier (Fig 1).
    Fig 1: Identifying Midline/Infinity Remote Amplifier Location
    G04184428Courtesy of DAIMLERCHRYSLER CORP.
  4. Pull amplifier inboard and then pull downward to remove from upper retaining clips.
  5. Disconnect two wiring connectors.
  6. Remove remote amplifier from vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.