2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Lower Control Arm: Description

WARNING: This page is about a different car, the 2004 Dodge Intrepid, 2004 Chrysler Intrepid, 2004 Chrysler Concorde, and 2004 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.

The lower control arm is a steel forging with 2 rubber bushings and a ball joint (Figure ). The bushing isolating the lower control arm from the front cradle/crossmember is a metal encased pivot bushing. The bushing isolating the lower control arm from the tension strut is a solid rubber bushing. The lower control arm is bolted to the cradle/crossmember using a bolt through the center of the pivot bushing. The tension strut is fastened through the center of the tension strut bushing and lower control arm. The lower control arm ball joint connects to the steering knuckle.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.