2000 Chrysler Intrepid BaseFACTORY OEM SERVICE PROCEDURE

Description - Strut Assembly (Front)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, 2003 Chrysler 300M, and 2002 Dodge Intrepid. However, it is still accessible from the selected car via links, so may be relevant.

The front strut and suspension of the vehicle is supported by coil springs positioned around the struts (Figure). The springs are contained between an upper seat, located just below the upper strut mount and a lower spring seat on the strut housing. A steering arm is permanently attached to each strut making it side specific.

The top of each strut assembly is bolted to the upper fender reinforcement (strut tower) through a rubber isolated mount.

The bottom of the strut assembly attaches to the top of the steering knuckle with two serrated through-bolts and prevailing torque nuts.

Coil springs are rated separately for each corner or side of the vehicle depending on optional equipment and type of vehicle service.

The components of the strut assembly listed below are serviceable if found to be defective (Fig 1):

  • Strut shaft retainer nut
  • Upper mount
  • Seat and bearing
  • Dust shield
  • Jounce bumper
  • Jounce bumper cup
  • Coil spring
  • Upper spring isolator
  • Lower spring isolator
  • Strut
Fig 1: Exploded View Of Strut Assembly Components
G00991643Courtesy of DAIMLERCHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.